McLaren Life banner

1 - 8 of 8 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter #1
Gents,

Seems to me the finish on the standard and lightweight wheels is a little less than satisfactory. I have specced the Lightweights in Silver Finish. My question is have any of you done special coatings or finishes other than the diamond cut finish ? While the standard finish seems bland, the diamond cut seems almost bling. Has anyone considered a polished finish ?

Bill
 

·
Registered
Joined
·
11,177 Posts
Gents,

Seems to me the finish on the standard and lightweight wheels is a little less than satisfactory. I have specced the Lightweights in Silver Finish. My question is have any of you done special coatings or finishes other than the diamond cut finish ? While the standard finish seems bland, the diamond cut seems almost bling. Has anyone considered a polished finish ?

Bill
I agree Bill,im not sure about a polished finish,but have been considering getting them powdercoated,i too have the lightweight silver finish and they do not wear well!
 

·
Registered
Joined
·
432 Posts
I would suggest getting the standard color wheels and customizing afterwards. I did that with mine... Regular finish and then powder-coated later. Very happy with the results.
 

·
Registered
Joined
·
432 Posts
Did you get it to match the ali rotor hub,or was that by accident??:)
Lets call it coincidence... it sounds better. The color is based on the "graphite gray" body color.
 
1 - 8 of 8 Posts
Top