McLaren Life banner

1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Hello. Sorry if im in the wrong subforum for this, but just wanted to post a recent project that i did. Im nathan with inspire automotive and i mostly do car body fabrication. For this project i was tasked to create GT3 parts so that it can be built over a 650S. the process started with a 3D scanning of the 650s. From there the gt3 body/parts could be modeled in 3D to fit the car considering some extent of fabrication work. Once the 3d model was done, the parts were CNC machined out of styrofoam...then had fiberglass molds made and finally fiberglass parts to use for the build. here are photos of the parts. if you have any projects i can do, you can contact me at [email protected] or 7084151276





















 

·
Registered
Joined
·
15 Posts
This is a late reply to this thread...are you still offering this? Most specifically, did you happen to make the wing and uprights?
 
1 - 2 of 2 Posts
Top